AutoMate Scientific Introduces the New BubbleStop™ Syringe Heater

Stop bubbles in your tubing - AutoMate Scientific introduces the new BubbleStop™ Syringe Heater

Bubbles in perfusion systems are caused by solution temperature changes. As solutions warm, they cannot hold as much gas, so they off-gas. This forms bubbles in perfusion tubing. It is especially true in inline heaters where the temperature rises dramatically.

The best cure for bubbles is to pre-warm your solutions. AutoMate Scientific introduces the BubbleStop™ Syringe Heater with integrated temperature feedback. Set the temperature on the BubbleStop a few degrees higher than room temperature or your inline heater, and the warmed solutions will off-gas in the reservoirs – not in your tubing.

Available in gravity and pressurized configurations with 35 ml or 60 ml syringe reservoirs.

Low noise for electrophysiology. Don't let another bubble slow you down.

For more information visit the company article page.