ReactaVisc RV3-HT1 the New High-Temperature Laboratory Viscometer from Hydramotion

Viscosity specialists Hydramotion Ltd has announced an extension to its ReactaVisc RV3 range of research-grade viscometers designed primarily for use in laboratory or pilot-scale reaction vessels. The new ReactaVisc RV3-HT1 can be used at temperatures up to 250°C without requiring any special cooling. Designed to ensure sensitive components in the head enclosure are protected from overheating, even though the sensor probe itself is at full fluid temperature.

The advantage of this is that there is no risk of measurement error resulting from the viscosity changes that would be caused by localised cooling of the fluid around the sensor.

Although robust, the ReactaVisc is light enough to be fitted to a laboratory-sized reaction vessel without requiring additional support. The compact enclosure takes up minimal space at the top of the vessel, leaving plenty of room for ancillary equipment, e.g. for stirring, reagent addition or temperature measurement. The sensor is a solid probe with no moving parts, bearings or seals that could wear out or fail in service, so routine maintenance is not required.

Viscosity is measured every two seconds and displayed on the separate VP550 signal processor unit. Output includes a 4-20 mA analogue viscosity signal and an RS485 serial data link. The optional ViscoLink software package enables measurement data to be logged and transferred to a PC for analysis.

The ReactaVisc is supplied with a fitting consisting of a compression nut plus an adaptor made to suit the desired installation. The shaft is passed through the adaptor and the compression nut is hand-tightened at the required position, forming an effective seal. The immersion depth is adjusted simply by loosening the fitting, moving as required, and re-tightening. No recalibration is needed when the viscometer is transferred from one vessel to another, since calibration is unaffected by the volume of fluid or the dimensions of the container.