Products & Reviews

The Empore™ High Performance Extraction Disk Plate differs in design from plates offered by other manufacturers and requires a specific vacuum manifold.  Manifolds supplied by different plate manufacturers are specific to the design of their plates and cannot generally be used with plates from other manufacturers.  In some cases, the use of spacers to raise/lower the height of a collection device inside the manifold may overco…

Replacement gaskets are available with the vacuum manifold assembly.  The gasket can become worn over time and the seal between the plate and the manifold will be affected.  This may result in poor vacuum pressure and negatively effect flow rates.  The gasket should be checked regularly and replaced when it becomes worn.

EmporeTM Tape Pads are intended for sealing unused portions of a 96-well solid phase extraction plate during vacuum processing to enable vacuum to be uniformly applied to each well being used.  Use a clean sheet each time for maximum sealing ability.  Note: these tape sheets are not intended for sealing collection plates prior to sample injection because the adhesive may clog the injection needle.

Empore Filter Aid 400 has been shown to improve flow rates and recoveries for separation and filtration of water samples containing suspended solids.  When placed on top of the Empore™ Extraction Disk at a depth of about 1 cm, Empore™ Filter Aid 400 acts as depth filter to inhibit the migration of suspended solids to the surface of the disk.  This reduces extraction time and improves rates and recovery of analytes.