Identification and optimization of the chemical, series of chemicals or bio-molecule that will interact with the target using impartial, expert opinion about the best equipment, services and the latest techniques
Agilent's Indicating Oxygen Trap is designed to be used in conjunction with any of our high capacity, non-indicating oxygen traps. When properly installed downstream from the non-indicating trap, the Indicating Oxygen Trap provides a visual indication of oxygen breakthrough before contamination reaches sensitive system components. Unlike adsorbent materials utilized in competitive products, our indicating media can be exposed…
Capture contaminants released by split injection systems Split vent traps capture contaminants released by split injection systems. Remember to replace the split vent cartridges every six months.An internal split vent trap is factory installed to ensure the split vent line does not clog, creating system errors or expensive repairs. Replacement cartridges are available. The optional external trap provides additional protecti…
Agilent now treats each premium 11mm inlet septa to eliminate sticking in the GC inlet. With our premium non-stick septa, you'll never have to scrape bits of septum out of your inlet. Agilent's premium septa also have a recess on the injection side, to guide the syringe needle to the same point with every injection.
Bleed and Temperature Optimized Non-Stick Septa (BTO) Agilent now treats each premium 11 mm inlet septa to eliminate sticking in the GC inlet. With our premium non-stick septa, you'll never have to scrape bits of septum out of your inlet. Agilent's premium septa also have a recess on the injection side, to guide the syringe needle to the same point with every injection.
Oxygen/moisture adsorbents team up to give you two functionalities in the same trap. Unlike some oxygen/moisture traps, these traps are disposable. Consider the safety, performance, and cost advantages of the Agilent capillary grade oxygen/ moisture traps (0T3) when comparing to heated, catalytic traps. The Agilent OT3 Trap contains a highly active, metal-containing, scrubbing material in an inert, aluminum body. This materi…
Find supplies for the following Teledyne Tekmar purge and trap instrumentation
Agilent's QuickSwap Capillary Flow Technology module and pre-swaged fused silica tubing restrictors can increase the productivity of your Agilent 5973N and 5975 inert MSD systems, allowing you to change columns without venting the MSD. QuickSwap not included.
SilTite (Metal) Ferrules Agilent offers a comprehensive selection of ferrules made of different materials and configurations for a a leak-free connection between the column and injector. SilTite ferrules are used with Agilent Ultimate Union and other Capillary Flow Technology products, including the Purged Effluent Splitter (G3180B), Deans Switch device (G2855B), and QuickSwap Mass Spec Interface (G3185B).
Even small leaks in the split/splitless injection port can reduce system sensitivity, cause poor signal to noise ration, increase column bleed, and even shorten column lifetime. Using a patent pending manufacturing process, our inlet gold seals eliminate tiny leaks from machining that can negatively impact your GC performance.
Agilent high-quality copper, stainless steel, and UltiMetal Plus tubing are manufactured and cleaned for chromatographic use. Agilent Tubing comes in different lengths and depending on your flow requirements, are available in 1/16 inch, 1/8 inch, or 1/4 inch. UltiMetal Plus tubing comes in 1/16 inch for inert environments.
