BubbleStop4 60ml Syringe Heater - Gravity
Bubbles in perfusion systems are caused by solution temperature changes. As solutions warm, they cannot hold as much gas, so they off-gas. This forms bubbles in perfusion tubing. It is especially true in inline heaters where the temperature rises dramatically. The best cure for bubbles is to pre-warm your solutions. AutoMate Scientific introduces the BubbleStop™ Syringe Heater with integrated temperature sensor and feedback. S…
The supplier does not provide quotations for this product through SelectScience. You can search for similar products in our Product Directory.
Bubbles in perfusion systems are caused by solution temperature changes. As solutions warm, they cannot hold as much gas, so they off-gas. This forms bubbles in perfusion tubing. It is especially true in inline heaters where the temperature rises dramatically. The best cure for bubbles is to pre-warm your solutions. AutoMate Scientific introduces the BubbleStop™ Syringe Heater with integrated temperature sensor and feedback. Set the temperature on the BubbleStop a few degrees higher than room temperature or your inline heater, and the warmed solutions will off-gas in the syringe reservoirs to the maximum gas concentration for that temperature. Even if they cool and re-heat again inside the perfusion tubing, they will not off-gas.
• Easy to remove full syringes
• Analog heating power - low noise for electrophysiology
• Completely shielded electronics plus external power supply
• Spill-proof design
• Range: ambient to 50°C liquid temperature
• Mounts to standard 1/2" rod
• Includes syringes and stopcocks